Technology

Mazama Energy's Carbon Chill Uses CO2 to Cool Geothermal Drill Bits

Martin HollowayPublished 4m ago3 min readBased on 1 source
Reading level
Mazama Energy's Carbon Chill Uses CO2 to Cool Geothermal Drill Bits
Image by blickpixel from Pixabay

Mazama Energy has developed a drilling system called Carbon Chill that uses carbon dioxide to cool the drill bit and bring rock cuttings to the surface, according to TechCrunch, which published its report on November 16, 2026.

The mechanism works through the drill string. Liquid CO2 is injected down the center of the string and heated to a supercritical state, a condition in which the fluid has no sharp boundary between gas and liquid. It is then expanded through a cone-shaped nozzle that resembles a rocket nozzle. The expansion cools the electronics and the drill bit, which is the core problem Carbon Chill is meant to address in high-temperature drilling.

Co-founder and CEO Sriram Vasantharajan said the company's rate of penetration (ROP, the speed at which the bit advances through rock) rose 20% over rates that were already very high. For rig economics, that matters directly: the faster a bit advances, the fewer rig-days a well consumes.

That link is central to the case for the technology. Drilling accounts for about 25% to 30% of the total cost of building a geothermal power plant, so a sustained gain in penetration rate reaches the capital budget of every project that uses it.

Mazama reported a milestone in October 2025, when it said it had drilled a well in Oregon that reached 629°F (331°C). That temperature sits in the range where conventional bits and downhole electronics face their hardest limits, and it is the environment Carbon Chill was built to handle.

In September, Mazama raised $135 million in a round led by Centaurus Capital and Doerr Capital. The company is backed by Khosla.

The temperature band Mazama is targeting is what the industry calls super-hot rock: rock where temperatures exceed 752°F (400°C). At those conditions, water turns supercritical and carries five to ten times more energy than water from traditional geothermal wells.

In my view, the significance of the approach depends on whether the penetration gain holds beyond a single well. A 20% improvement is a strong early signal, but geothermal formations vary widely in hardness, fracturing and fluid content. The open questions are how the CO2 loop performs across those conditions and what it adds to surface handling and rig operations.

The broader context here is the energy density argument. If drilling costs fall while bits and downhole tools survive temperatures above 400°C, the economics of supercritical geothermal become a question of engineering rather than resource availability. For a sector long limited by the cost of reaching heat, that is a development worth tracking closely.